Suunto D5 Manual De Instrucciones página 12

8 COMPLIANCE
8.1 CE
Hereby, Suunto Oy, declares that the radio equipment type DW182 is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: suunto.com/EUconformity.
8.2 EU depth gauge standard
EN13319 is a European diving depth gauge standard. Suunto dive computers are
designed to comply with this standard.
8.3 FCC / ISED Regulatory notices (USA / Canada)
Modification statement
Suunto has not approved any changes or modifications to this device by the
user. Any changes or modifications could void the user's authority to operate the
equipment.
Interference statement
This device complies with Part 15 of the FCC Rules and Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
Wireless notice
This device complies with FCC/ISED radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
8.4 CAN ICES-3 (B) / NMB-3 (B) (Canada)
This Class B digital apparatus complies with Canadian ICES-003.
12