Suunto D5 Manual De Instrucciones página 6

WARNING: DO NOT DIVE WITH A GAS IF YOU HAVE NOT PERSONALLY
VERIFIED ITS CONTENTS AND ENTERED THE ANALYZED VALUE INTO YOUR
DIVE COMPUTER! Failure to verify tank contents and enter the appropriate gas
values where applicable into your dive computer will result in incorrect dive
planning information.
WARNING: Using a dive planner software such as in Suunto DM5 is not a
substitute for proper dive training. Diving with mixed gases has dangers that are
not familiar to divers diving with air. To dive with Triox, Heliox and Nitrox or all of
them, divers must have specialized training for the type of diving they are doing.
WARNING: Do not use Suunto USB Cable in areas where flammable gases are
present. Doing so may cause an explosion.
WARNING: Do not disassemble or remodel Suunto USB Cable in any way. Doing
so may cause an electric shock or fire.
WARNING: Do not use Suunto USB cable if cable or parts are damaged.
WARNING: You must only charge your device using USB adapters that comply
with the IEC 62368-1 standard and have a maximum output of 5 V. Non-compliant
adapters are a fire hazard and a risk to personal injury and might damage your
Suunto device.
CAUTION: DO NOT allow the connector pins of the USB cable to touch any
conductive surface. This may short circuit the cable, making it unusable.
2.2 Emergency ascents
In the unlikely event that the dive computer malfunctions during a dive, follow
the emergency procedures provided by your certified dive training agency to
immediately and safely ascend.
3 BEFORE YOU DIVE
Make sure that you fully understand the use, displays, and limitations of your
dive instruments. If you have any questions about the safety and regulatory
information or the dive instrument, contact your Suunto dealer before diving with
the dive computer. Always remember that YOU ARE RESPONSIBLE FOR YOUR
OWN SAFETY!
Before leaving on a dive trip, inspect your dive computer thoroughly to make sure
everything is functioning properly.
At the dive site, perform your manual pre-dive safety checks on each device before
entering the water.
3.1 Dive computer pre-dive safety check
Ensure that:
1. Suunto D5 is in the correct dive mode and the display is working as expected.
2. Altitude setting is correct.
3. Personal setting is correct.
4. Deep stops are set correctly.
5. Unit system is correct.
6. Compass is calibrated. Start the calibration manually in the menu under
General » Compass » Calibrate to also confirm that the dive computer audible
6