Installation; Transport; Intermediate Storage; Unpacking - Grundfos Conex DIS-G Instrucciones De Instalación Y Funcionamiento

9. Installation

Warning
Before assembling, disconnect the power
supply!
Enclosure class IP65 is only guaranteed if
the terminal covers are closed and the
appropriate cable glands or dummy caps
fitted.

9.1 Transport

Risk of malfunction or damage to the
Caution
®
Conex DIS-G! Do not drop the device.
9.1.1 Delivery
®
The Conex DIS-G is delivered in a cardboard box.
Leave the device in the packaging during transport
and intermediate storage.
9.1.2 Return
®
Return the Conex DIS-G in its original packaging or
equivalent.
Risk of malfunction or damage to the
®
Conex DIS-G! Grundfos accepts no
Caution liability for damage caused by incorrect
transportation or missing or unsuitable
packaging of the device!

9.2 Intermediate storage

Permissible storage temperature: -20 °C to +65 °C
For information on storing the sensors, see
Note
the manual of the gas sensors.

9.3 Unpacking

1. Check the device for damage.
Install as soon as possible after unpacking.
2. Do not install or connect damaged devices!
Retain the packing material or dispose of it
Note
according to local regulations.

9.4 Installation requirements

®
Conex DIS-G
• Dry room
• Room temperature: 0 °C to +45 °C
• Vibration-free location.
Sensors
• Dry room.
– Avoid the sensor getting wet! Make sure to
locate it outside the range of the sprinkling
installation.
• Room temperature according to the technical
data for the relevant sensor.
• Vibration-free location.
• Protect the sensor from direct heat, sunlight and
strong draughts!
For additional information on sensor
Note
installation, see the manual of the gas
sensors.
Gas sensors should not be mounted close
Caution to major sources of interference such as
large machines, etc.
If these assembly requirements are not
observed, there may be damage to the
Caution
measuring device or incorrect
measurements!
15