Care and maintenance
9.3
Cleaning the brewing unit
To avoid damage to the appliance, we recommend cleaning the brewing
unit once a week.
Fig. 22: Removing the brewing unit
Requirement: The appliance is switched off.
1. Open the cover (11). To do this, reach into the recess on the right of the
appliance and pull the cover off upwards.
2. Press and hold the red lever (40) on the brewing unit handle (14) and
turn the handle clockwise until it engages at the stop.
3. Pull the brewing unit out of the appliance using the handle.
4. Rinse the entire brewing unit thoroughly from all sides under running
water. Make particularly sure that coffee residues are removed from the
sieve (41).
5. Allow the brewing unit to drip dry.
6. Use a soft, dry cloth to remove coffee residues from the surfaces inside
the appliance.
7. Insert the brewing unit into the appliance. Press and hold the red lever
on the brewing unit handle and turn the handle counter clockwise until
it engages at the stop.
8. Close the cover. To do this, insert the bottom of the cover into the appli-
ance and swing it up until it engages.
38
11
41
14
40