Pegasolift W12 Guia Uso Y La Mantenimento página 180

PUTTING IN FUNCTION AND STACKER UTILISATION
PRELIMINARY CONTROLS:
The stacker ready to use must be in the following conditions:
1) Start switch: deactivated with the key taken out.
2) Cable of the battery charger: diconnected.
3) Tiller bar: in vertical position
4) Lifting group: completely lowered.
FORWARD AND BACKWARD MOVEMENT OPERATIONS:
FORWARD
1 - BRAKING
2 - RUNNING
1
2
1
LIFTING AND LOWERING OPERATIONS
1) Introduce the forks in the lower part of the pallet on which the load is put with
maximum of care and minimum speed; it is recommended for a bigger stability of
the load to introduce completely the forks (see page 11 "Transport of load").
2) Control that the load is equally distributed on the forks and the positions of the
barycenter is within the limits shown by the arrow on the stacker.
3) For lifting: keep pushing the button for lifting (reference page 14 "Tiller head" no. 6)
until the desired height is achieved.
4) For lowering: keep pushing the button for descent (reference page 14 "Tiller head"
no. 4) until the desired height is achieved.
ATTENTION!
executed only with the stacker completely stopped.
W10 INOX
BACKWARD
control buttons for movement: turning in the
Fig. B
sense of watch needles the stacker moves
forward, in the contrary sense the stacker
moves backward.
Controlling in an adequate manner the
turning there it is easy to control the stacker
speed.
It is advised to avoid abrupt and repeated
starts and slowing down in order to avoid
overheating of the motor and rapid
discharge of the battery.
The load lifting and lowering operations should be
15
1) Introduce the start key.
2) Push simultaneously
with both hands the tiller
head and bring it in a quite
horizontal position: the
positions completely
horizontal and vertical
forbid the forward and
reverse movement (figure
B).
3) Operate the butterfly
UK15