Pegasolift W12 Guia Uso Y La Mantenimento página 49

6) screw again the screws of the brush elements (2) to realize a good electric contact.
7) close the strip covering the brushes.
NOTE: during these operations pay much attention to not let screws, washers or another
material to fall in the interior of the motor.
OTHER PERIODICAL CONTROLS
Every 500 hours check if there are not damages or burns on the resorts pushing the
brushes or on the rotor collector.
Every 1000 hours check if the bearings in double scheme with grease at high
temperature have not leakages; check the perfect fastening of the fittings, the good
fastening of electrical contacts and that the insulation against the mass is over 2
Megohm.
2
1
W12
TRACTION WHEEL MAINTENANCE
SOSTITUZIONE DEI RULLI ANTERIORI
1
3
Also the front rollers can exhaust itself; if is
necessary operate as follow:
1- Lift the forks and disconnect the start
switch (reference page 14 " Instruments"
n° 1)
2- Put the truck on safety supports
3- To take off the roller (3) remove the
retaining ring for shaft (1) and the rotation
pin (2).
4- Replace the damaged roller, insert the
rotation pin (2) fixing it with the retaining
ring for shaft (1).
23
UK23