Franklin Electric SDCP-SUB0723 Manual Del Usuario página 46

MAINTENANCE
Troubleshooting
Codes Fault
F F 3 3 7 7 Fan Speed Fault •
F F 3 3 8 8 Internal Over
Temperature
F F 3 3 9 9 RTD Device
Missing
F F 4 4 1 1 MultiDrive
Sensor
Mismatch
F F 4 4 2 2 MultiDrive
Firmware
Mismatch
F F 4 4 3 3 MultiDrive
Comm Fault
46
Possible Causes
One or more of the internal
fans are not working
• Airflow is impeded
• High ambient temperature
• Drive is in direct sunlight
• Airflow is impeded
• PT100 Select is set to "En-
abled" and no RTD device is
connected to the drive.
• Drives using the built-in Multi-
Drive function are configured
with pressure sensor types that
do not match
• Drives using the built-in Multi-
Drive function have firmware
versions that are not matched
• Improper MultiDrive cable
connection
• MultiDrive cable is damaged
Corrective Action
• Check fan connections to the Control Board.
• Fan blocked or inoperable, ambient above 104 °F (40 °C), di-
rect sunlight, air flow channel blocked
• Replace internal stirring fans or relocate drive as necessary
• Remove debris from fan intake/exhaust
• The drive has exceeded max rated internal temperature of
176 °F (80 °C), and needs to drop below 167 °F (75 °C) to
restart
• Replace fan or relocate drive as necessary
• Remove debris from fan intake/exhaust
• Switch PT100 Select to "Disabled"
• Connect the RTD device to the drive
• Drives using the built-in MultiDrive function must have
matching pressure sensor types, either a traditional pressure
sensor or a pressure transducer.
• If both drives are configured with a pressure transducer, the
transducers must both be PSI type or bar type.
• Firmware version of one or more drives must be updated to
a matching firmware version using the SubDrive Connect Plus
mobile app.
• Check MultiDrive cable connections
• Replace MultiDrive cable
• Check dip switch setting for terminating resistor.