Product Information; Description; Features - Franklin Electric SDCP-SUB0723 Manual Del Usuario

PRODUCT INFORMATION

Description

The Franklin Electric SubDrive Connect Plus family includes variable frequency
drives (VFD) designed to control and protect three-phase motors up to 30 hp.
These drives provide enhanced pump performance for commercial, agricultural,
and irrigation water system applications in a small, self-contained NEMA 3R pack-
age. Many advanced features are included that are typically available only in large,
panel-based, general-purpose industrial drives.
The SubDrive Connect Plus adjusts motor and pump speeds to maintain constant
water pressure, even as user demands (water flow) change. Additional pumping
application features include broken pipe protection, pipe fill mode, and multidrive/
multi pump capabilities.
Setup is fast and easy, using simple DIP switches and an LCD menu with push but-
tons—no complicated programming is required. The drive can also be configured
and monitored using Bluetooth and the SubDrive Connect Plus mobile app.
The SubDrive Connect Plus series is designed to operate three-phase motors with
three-phase incoming power. 230 VAC models also provide the capability to oper-
ate a three-phase motor with single-phase incoming power.

Features

C C o o n n f f i i g g u u r r a a t t i i o o n n
• Compatible with three-phase submersible and surface pumps and motors, including Franklin Electric
MagForce permanent magnet submersible motors
• Simple programming and easy setup with built-in application defaults
• MultiDrive function for Lead/Lag pump operation
O O p p e e r r a a t t i i o o n n
• Easy-to-read LCD display for system status identification
• User-defined motor frequency range and control inputs.
• Run and alarm relays provide switching for external monitors or systems
• Advanced filtering to remove radio frequency interference
P P r r o o t t e e c c t t i i o o n n
• Protection against short circuit, incorrect wiring, underload, overload, drive overheat, under-voltage,
overvoltage, phase loss, phase imbalance, output open phase, overpressure, and sensor fault
• Slow-start and pipe fill features prevents water hammer and increases motor life
• Broken-pipe detection
• User-defined underload sensitivity and off time
• Ground Fault Protection for motor output
• External inputs for Dual Pressure setpoints, Run/Stop, and Hand/Auto
• Moisture Sensor input stops pump when water is detected. Refer to
• PT100/PT1000 input for motor temperature alarm and fault
PRODUCT INFORMATION
"Accessories" on page 58.
Description
7