Franklin Electric SDCP-SUB0723 Manual Del Usuario página 56

SPECIFICATIONS
Programming Defaults
Default
Parameter
Value
Alternation Timer
Alternation
24
Timer
Analog Out-
Speed
put
Selection
Run/Stop
Run Open
Input
Coast (SUB)
Stop Mode
Decel (CEN)
Stabilizer
Disabled
Mode
Stabilizer
10.0
Gain 1
Stabilizer
2.0
Gain 2
Stabilizer
50.00
Frequency 1
Stabilizer
120.00
Frequency 2
Stabilizer
Bus Enabled
Prediction
Output
Phase Open Enabled
Fault Enable
Output
Phase Open 50
Level
Input Phase
Enabled
Open
Broken Pipe
Disabled
Mode
56
Range
Units
• Disabled
N/A
• Timer
Hours 0.1 to 168
• Speed
N/A • Analog
Repeater
• Run Open
N/A
• Run Closed
• Coast
N/A
• Decelerate
• Enabled
N/A
• Disabled
Stabilizer Gain 2 to
N/A
50.0
0.0 to Stabilizer
N/A
Gain 1
Hz 1.00 to 50.00
Hz 50.00 to 120.00
• Enabled
N/A
• Disabled
P P r r o o t t e e c c t t i i o o n n s s S S e e t t u u p p
• Enabled
N/A
• Disabled
% 5 to 50
• Enabled
N/A
• Disabled
• Enabled
N/A
• Disabled
Set Parameter Via:
Program- Mobile
DIP
ming App
Switch
No No Yes
No No Yes
Yes No Yes
No Yes Yes
No No Yes
D D i i a a g g n n o o s s t t i i c c s s
No No Yes
No No Yes
No No Yes
No No Yes
No No No
No No Yes
No No Yes
No No Yes
No No Yes
Yes No Yes
Change
while Description
Running
Enables or disables alternation
of the Lead drive in multidrive
No
configuration. This balances the
load amongst drives.
Timer to rotate the Lead status
among drives in multidrive
No
configuration.
Sets analog output to repeat in-
put pressure transducer signal
No
or the speed of the drive as a
4-20mA signal.
Changes the polarity of the
Run/Stop Input on the drive.
This can be changed using the
No
Menu screen and buttons or the
mobile app.
Sets the stopping operation of
the drive to either decelerate
Yes using the drive to control slow-
down or allow the pump and
motor to coast.
Enables or disables stabilizer
No
mode
Sets the gain of the stabilizer at
No
low frequencies
Sets the gain of the stabilizer at
No
high frequencies
Sets the frequency at which
No
Gain 1 is active for the stabilizer
Sets the frequency at which
Yes
Gain 2 is active for the stabilizer
Enables or disables DC bus pre-
No
diction feature
Enables or disables output open
No
phase protection
Adjusts sensitivity level of open
No
phase protection
Enables or disables Input open
No
phase protection
Enables or disables broken pipe
No
protection