Franklin Electric SDCP-SUB0723 Manual Del Usuario página 48

MAINTENANCE
Troubleshooting
Display
Condition
Motor
High
Frequency
Pressure
Motor
Audible
Frequency
Noises
No Display
None
Cannot
Connect to Bluetooth
Drive Icon Off
Bluetooth
Motor
RFI-EMI
Frequency
Interference
48
Possible Cause
• Pressure sensor setting
• Shorted sensor wire
• Fan, hydraulic, plumbing
• dV/dt filter
• Control Board cable
disconnected or loose
• Attempting to connect to incor-
rect drive
• Out of Bluetooth range of drive
• Poor grounding
• Wire routing
Corrective Action
• Adjust pressure sensor
• Remove sensor wire at Control Board, if drive stops
running, wire may be shorted
• Remove sensor wire at Control Board, if drive
continues to run, replace Control Board
• Remove sensor wire at new Control Board, if drive continues
to run, replace drive
• Verify condition of sensor wire and repair or replace if
necessary
• For excessive fan noise, replace fan
• If fan noise is normal, drive will need to be relocated to a
more remote area
• If hydraulic, try raising or lowering depth of pump
• Pressure tank location should be at entrance of water line in-
to house
• For EMI noise, change switching frequency to 8 kHz if
using a CEN model for surface applications, otherwise it is
locked at 2.5 kHz.
• Verify cable connection between Power Board and Control
Board
• Ensure the Bluetooth SSID (Drive ID) you are connecting to
matches the drive you wish to connect to
• Bluetooth range is 100 feet line-of-sight, must be closer to
drive if walls or floors are between you and the drive
• Bluetooth module not responding, cycle power to drive
• Cycle Bluetooth radio on mobile device, refresh Bluetooth
connection list
• Adhere to grounding and wire routing recommendations
• An additional external filter may be needed.