Bahco TAW Serie Manual De Instrucciones página 11

STD
135 Nm wrench:
Maximum Target Torque = offset *4,1 + 135
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
800 Nm wrench:
Maximum Target Torque = offset *7,6 + 800
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
SLIM
12 Nm wrench:
Maximum Target Torque = offset * 0.522 + 12
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
Note: When using a negative offset, entering a target torque greater than maximum values
above may cause an overtorque error before reaching fastener target torque and possibly
damage wrench.
VIEWING STORED TORQUE AND ANGLE DATA
Torque data is stored in memory after each torque cycle if applied torque has reached target value.
Torque and angle data is stored in memory after each angle cycle if applied angle has reached target
value. Memory Indicator is displayed when data is stored in non-volatile memory.
1. To view stored torque and angle data, from target torque or angle screen, press and hold ENTER
button for 3 seconds.
2. Highlight SHOW DATA menu selection by pressing UP/DOWN buttons then press ENTER button
to display Show Data screen.
3. In Show Data screen, scroll through each stored data record by pressing UP/DOWN buttons.
Example:
0002 = Show Data List Counter: TQ = Peak torque value
0001 = Show Data List Counter: TQ = Peak torque value: ANG = Peak angle value
4. Pressing ENTER button while on Show Data screen returns to main menu.
131
127
123
119
792
785
777
770
11.48
10.96
10.43
9.91
340 Nm wrench:
Maximum Target Torque = offset *6,1 + 340
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
30 Nm wrench:
Maximum Target Torque = offset * 1.3 + 30
Offset (cm) Max Target (Nm)
-1
-2
-3
-4
334
328
322
316
28.70
27.40
26.10
24.80
11