Bahco TAW Serie Manual De Instrucciones página 23

STD
TARGET BEEP SETUP (ONLY ON SLIM & SCR)
This function will allow user to enable or disable audio feedback when target torque or angle is
reached. Audio feedback occurs on torque or angle over range (red LED) regardless of this setting.
1. From Settings menu, use UP/DOWN buttons to highlight TARGET BEEP selection then press
ENTER button.
2. TARGET BEEP screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE (factory default) or DISABLE selection.
4. Press ENTER button to accept selection and exit to Settings menu.
AUTO BACKLIGHT SETUP
This function will allow user to enable or disable backlight from turning on during torque or angle measurement.
1. From Settings menu, use UP/DOWN buttons to highlight AUTO BACKLIGHT selection then press
ENTER button.
2. AUTO BACKLIGHT screen is displayed.
3. Use UP/DOWN buttons to highlight ENABLE (factory default) or DISABLE selection.
4. Press ENTER button to accept selection and exit to Settings menu.
SLIM/SCR
23