Bahco TAW Serie Manual De Instrucciones página 6

TAW AND TAS SERIES
USER INSTRUCTIONS
SLIM & STD
FIGURE 1
BATTERY
CONDITION
USB DATA STORAGE
CONNECTOR ALERT
SCR
FIGURE 1
BATTERY
CONDITION
PROGRESS
LIGHTS
DATA STORAGE
ALERT
Install fresh Alkaline "AA" cells into handle of tool.
TOOL POWER ON SEQUENCE
Note: Do not turn on tool while torque is applied, otherwise torque zero offset will be incorrect and
tool will indicate a torque reading when torque is released. If this occurs, re-zero tool by momentarily
pressing POWER button while tool is on a stable surface with no torque applied.
1. Turn On Tool.
While holding tool still, press POWER button. BAHCO logo will be displayed followed by torque and
angle re-zeroing screens (if angle mode has been previously selected). Target TORQUE or ANGLE
screen will now be displayed (depending on previous measurement mode selected).
Note: By simultaneously pressing the ENTER and UNITS U buttons, the keypad can be locked
to prevent inadvertent button presses while griping the screwdriver body. The Lock Icon is
displayed when the keypad is locked. To unlock the keypad, press the ENTER – UNITS U –
ENTER buttons in sequence (on screwdrivers (SCR) only).
Note: If the keypad was locked when powered down, on power up, the keypad will remain locked
and will require the keypad unlock button sequence of ENTER – UNITS U – ENTER to become
functional again (on screwdrivers (SCR) only).
2. Select Measurement Mode.
Toggle between target TORQUE and ANGLE screens by repeatedly pressing ENTER button.
TORQUE AND/OR
ANGLE DISPLAY
PROGRESS MODE ON/OFF AND
LIGHTS COUNT RE- ZERO BUTTON
PROGRESS UNITS AND PRESET
LIGHTS ENTRY BUTTON
TORQUE AND/OR ON/OFF AND
ANGLE DISPLAY RE- ZERO BUTTON
MODE INCREMENT
COUNT BUTTON
PROGRESS UNITS AND PRESET DECREMENT
LIGHTS ENTRY BUTTON BUTTON
PROGRESS LIGHTS
Yellow:
First light indicates 40% of
target torque or angle reached,
INCREMENT MODE SELECT AND
BUTTON MENU ENTRY BUTTON
Second indicates 60% of
target reached,
Third indicates 80% of
target reached.
Green:
AUDIBLE
Indicates target torque or angle
ALERT
reached.
Red:
Indicates exceeded torque or
angle target +4% for targets
above 20% to 100% of full
DECREMENT LCD BACKLIGHT
scale or target +10% for targets
BUTTON AND PEAK
TORQUE/ANGLE
from 5% to 20% of full scale
RECALL BUTTON
or exceeded maximum Preset
target. (Note: Yellow lights also
turn on with red)
PROGRESS LIGHTS
AUDIBLE
ALERT
MODE SELECT AND
Yellow:
MENU ENTRY BUTTON
1/2 second on/off flashing
indicates 40% of target torque
or angle reached.1/4 second
flashing indicates 60% of
target reached. Continuous on
indicates 80% of target reached.
Green:
Indicates target torque or angle
reached.
Red:
LCD BACKLIGHT
Indicates exceeded torque or
AND PEAK
angle target plus 4% or
TORQUE/ANGLE
exceeded madimum Preset
RECALL BUTTON
target.