Important Safety Instructions - Bahco TAW Serie Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

WARNING.
RISK OF FLYING PARTICLES.
Over-torquing can cause
breakage. Force against flex
stops on flex head can cause
head breakage. An out of
calibration angle tool can
cause part or tool breakage.
Broken hand tools, sockets
or accessories can cause
injury. Excess force can
cause crowfoot or flare nut
tool slippage.
• Read this manual completely
before using ELECTRONIC
TOOL.
• To insure accuracy, work
must not move in angle
mode.
• For personal safety and to
avoid tool damage, follow
good professional tool
and fastener installation
practices.
• Periodic recalibration is
necessary to maintain
accuracy.
• Wear safety goggles, user
and bystanders.
• Be sure all components,
including all adaptors,
extensions, drivers and
sockets are rated to match or
exceed torque being applied.
• Observe all equipment, system
and manufacturer's warnings,
cautions and procedures when
using this tool.
• Use correct size socket for
fastener.
• Do not use sockets showing
wear or cracks.
• Replace fasteners with
rounded corners.
• To avoid damaging tool:
Never use tool with power
off. Always turn ON tool
so applied torque is being
measured.
• Do not press POWER while
torque is applied or while tool
is in motion.
• Never use this tool to break
fasteners loose.
3