Bahco TAW Serie Manual De Instrucciones página 4

TAW AND TAS SERIES
• Do not use extensions, such
as a pipe, on handle of tool.
• Check that tool capacity
matches or exceeds
each application before
proceeding.
• Verify calibration if dropped.
• Make sure ratchet direction
lever is fully engaged in
correct position.
• Verify calibration of tool if you
know or suspect its capacity
has been exceeded.
• Do not force head of flex
head drives against stops.
• Always adjust your stance to
prevent a possible fall should
something give while using
tool.
• Do not attempt to recharge
Alkaline cells.
• Store tool in dry place.
• Remove batteries when
storing tool used for periods
longer than 3 months.
WARNING.
Electrical Shock Hazard.
Electrical shock can cause
injury. Metal handle is not
isolated.
Do not use on live
electrical circuits.
SAVE THESE
INSTRUCTIONS
DISCLAIMER
Operation of the tool is
not warranted in an EU
member state if operating
instructions are not in that
State's language.
Contact BAHCO if a
translation is needed.