Bahco TAW Serie Manual De Instrucciones página 18

TAW AND TAS SERIES
4. MAXIMUM ANGLE screen is displayed next. MAXIMUM ANGLE is angle value above which red pro-
gress lights turn on. Initial MAXIMUM ANGLE value will be MINIMUM ANGLE plus 4%. MAXIMUM AN-
GLE value can be set to any value greater than MINIMUM ANGLE by pressing UP/DOWN buttons. Once
desired value has been set, press ENTER button.
5. BATCH COUNT screen is displayed next. Default value is zero. Batch count range is 0 to 99. Press
UP/DOWN buttons to increment/decrement batch count. Mode Count increments each time target angle
is reached if a batch count of zero is entered. Mode Count decrements if a non-zero batch count is
entered and resets to batch count value when count reaches zero. Once desired batch count value has
been set, press ENTER button.
6. PSET target screen is displayed labeled with next available PSET number from 01 to 10.
7. To enter additional angle presets, repeatedly press ENTER button until target angle screen is displayed and
repeat steps above.
STD
SLIM/SCR
EDITING A PRESET
Edit PSET function gives user ability to edit stored PSETS on tool.
1. From Preset screen to be edited, press and hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP/DOWN buttons then press ENTER button.
4. MINIMUM TORQUE or MINIMUM ANGLE screen is displayed. Value can be changed by pressing
UP/DOWN buttons. Once desired torque or angle value has been set, press ENTER button.
5. MAXMUM TORQUE or MAXIMUM ANGLE screen is displayed next. Value can be changed by
pressing UP/DOWN buttons. Once desired torque or angle value has been set, press ENTER button.