Advanced Configuration - Bahco TAW Serie Manual De Instrucciones

TAW AND TAS SERIES

ADVANCED CONFIGURATION

Advanced configuration is accessed from CONFIGURE menu selection on main menu.
1. From target torque or angle screen, press and hold ENTER button for 3 seconds.
2. Highlight CONFIGURE menu selection using UP/DOWN buttons.
3. Press ENTER button to display Configure menu.
Menu Selections:
EXIT - Exits Configure menu and returns to target torque or angle screen.
MODE SETUP - Displays tool mode setup menu.
DELETE PRESETS - Displays delete all presets menu.
CALIBRATION - Displays tool calibration menu (password protected).
SET DATE/TIME - Displays clock date and time entry screens.
SET CAL INTRVAL - Displays calibration interval setup screen.
4. To exit Configure menu and return to target torque or angle screen, press ENTER button while
EXIT menu selection is highlighted.
STD
Note: All user configurable settings are stored in non-volatile memory and are retained while power is off.
holds for the type of battery used.
MODE SETUP
ATTERY TYPE selection then press
Mode setup menu allows user to enable/disable Torque THEN Angle mode.
1. From Configure menu, press ENTER button while MODE SETUP selection is highlighted.
2. Mode Setup menu is displayed.
used.
Menu Selections:
menu.
EXIT - Exits Mode setup menu and returns to Configure menu screen.
THEN DISABLED - Displays THEN Mode enable/disable screen.
3. Use UP/DOWN buttons to highlight menu selections.
4. Press ENTER button while EXIT menu selection is highlighted to return to Configure menu.
STD
ENABLE/DISABLE TORQUE THEN ANGLE MODE
This function will allow user to enable or disable Torque THEN Angle Mode.
1. From Mode Setup menu, use UP/DOWN buttons to highlight THEN DISABLED (factory default)
selection then press ENTER button.
If Alkaline battery is replaced with
2. TQ THEN ANGLE enable/disable screen is displayed.
should be changed so battery level
3. Use UP/DOWN buttons to select ENABLE or DISABLE selection.
PLACE) will not be impacted, how-
4. Press ENTER button to accept selection and exit to Mode Setup menu.
discharge time.
tion on main menu.
on for 3 seconds.
.
SLIM/SCR
Note: All user configurable settings are stored in non-volatile memory an
MODE SETUP
Mode setup menu allows user to enable/disable Torque THEN Angle m
1. From Configure menu, press ENTER button while MODE SETUP se
2. Mode Setup menu is displayed.
Menu Selections:
EXIT - Exits Mode setup menu and returns to Configure menu scree
THEN DISABLED - Displays THEN Mode enable/disable screen.
3. Use UP/DOWN buttons to highlight menu selections.
4. Press ENTER button while EXIT menu selection is highlighted to ret
SLIM/SCR
SLIM/SCR
ENABLE/DISABLE TORQUE THEN ANGLE MODE
This function will allow user to enable or disable Torque THEN Angle M
1. From Mode Setup menu, use UP/DOWN buttons to highlight THEN
selection then press ENTER button.
2. TQ THEN ANGLE enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or DISABLE selection.
4. Press ENTER button to accept selection and exit to Mode Setup me
SLIM/SCR