Civco Verza Manual De Instrucciones página 5

Tracking Bracket
with Verza™ Guidance System
ASSEMBLING TRACKING SYSTEM
1. With latch open, align bracket with locating features on transducer.
2. Close latch around transducer and click to secure. Ensure bracket is securely attached.
3. Place general purpose sensor onto sensor mount.
4. Press general purpose sensor toward bracket and click to secure.
WARNING
Ensure general purpose sensor is securely attached. Failure to do so could result in inaccuracy.
n
USING GUIDANCE SYSTEM
1. Place an appropriate amount of gel inside cover and/or on transducer face. Poor imaging may result if no gel is
used.
2. Insert transducer into cover making sure to use proper sterile technique. Pull cover tightly over transducer face to
remove wrinkles and air bubbles, taking care to avoid puncturing cover.
3. Secure cover with enclosed bands.
4. Inspect cover to ensure there are no holes or tears.
5. Remove Verza from guide storage column of gauge insert tree.
6. Using proper sterile technique, place Verza guide onto VerzaLink locating feature.
7. Rotate guide locking lever into locked position. Ensure guide is securely attached.
25G, 22G, 21G,
20G, 18G, 17G,
16G, 15G, 14G,
12F, 10F, 9F, 8F, 7F
3
English