Power Connections - JVC BD-X200E Instrucciones

Power Connections

Connect the AC adaptor (included) to the DVD recorder.
Power cord
(included)
AC
OPERATE
OPERATE
indicator
AUDIO
CH1
CH2
PHONES
Note
A small amount of current will be required by the DVD
recorder when in Operate Off mode.
AC adaptor
(included)
1.
2.
REV
3.
4.
VIDEO
IN LINE OUT INPUT
LEVEL
Y/C
IN
DV IN/OUT
USB
LAN
SIGNAL
GND
Clamp
Screw
Connect the AC adaptor's DC cord to the DVD
recorder's DC IN terminal.
Secure the DC cord using the DC power cord
clamp in order to
disconnection.
q Remove the screw and then the clamp.
w Insert the DC cord into the clamp, and then secure the
clamp to the DVD recorder.
Connect the power cord (included) to the AC
adaptor's AC IN terminal.
Insert the power cord into an electrical outlet.
● Power will be supplied to the DVD recorder and the
OPERATE indicator will be lit up in red. (Operate Off mode)
CAUTION
● Always use the AC adaptor provided with the DVD
recorder.
The use of other power sources should be avoided.
● Do not disconnect the DC cord or power cord during
recording or playback.
In the case of DVD-R discs, failure to observe this
precaution will result in the discs becoming unusable.
In the case of DVD-RW discs, it will be necessary to erase
all data from the disc and to start recording again from
the beginning.
AUDIO
CH1
IN OUT
4dB
8dB
CH2
REMOTE
DC 19V
DC IN
prevent accidental
E-23