Preparing A Disc For Recording - JVC BD-X200E Instrucciones

Settings & Controls for Recording

Preparing a Disc for Recording

This DVD recorder is capable of recording to DVD-R and DVD-RW (in video mode).
DVD-R : Only discs that conform with DVD-R Standard 2.0 (video mode) can be used.
DVD-RW : Discs of Version 1.1 or later can be used.
Although Version 1.1 of DVD-RW standards allows the selection of video mode and VR mode for recording, this
DVD recorder performs recording in video mode only.
* Version 1.0 of the DVD-RW standards does not support video-mode recording, and for this reason, the corresponding
discs cannot be used.
In terms of recording characteristics, DVD-R and DVD-RW (video mode) differ as follows.
DVD-R
DVD-RW (video mode) : After viewing a disc, all data can be erased and it can be used to record new content.
The condition of the disc being used will dictate the available recording options as follows.
Blank disc
DVD-R
A disc recorded on using this DVD recorder
but not yet finalized.
Blank disc
DVD-RW
A disc recorded on using this DVD recorder
but not yet finalized.
A recorded disc from which data is to be
erased.
Notes
● If data has been erased from a disc using a different DVD recorder, it may not be possible to record new content to it using
this recorder. To avoid this type of situation, ensure that this DVD recorder is used to erase recorded data.
● New content cannot be recorded to discs that have been finalized.
● Regardless of whether or not finalization has been carried out, it will not be possible to use this DVD recorder to record new
content to a DVD-R or DVD-RW that has been recorded on using other devices.
Erasing All Data From a Disc
DISC MENU screen
DISC MENU
MENU
FINALIZE
DISC ERASE
DISC ERASE
E-30
: Each disc can be recorded only once. Erasing of data and re-recording are not possible.
Disc condition
1.
2.
CANCEL 3.
EXECUTE
4.
5.
New content can be recorded. A new title is created and recording
starts from that title's first chapter.
A new title is created in the unused section of the disc, and recording
starts from that title's first chapter.
New content can be recorded. A new title is created and recording
starts from that title's first chapter.
A new title is created in the unused section of the disc, and recording
starts from that title's first chapter.
Erase the recorded data (as described below), and then record
new content.
Insert the DVD-RW from which data is to be erased.
Press the SET UP button to display the Setup Menu.
Use the 7 and 6 buttons to select DISC MENU and then press
the SET button.
● The DISC MENU screen will appear.
Use the 7 and 6 buttons to select DISC ERASE and then press
the SET button.
● A list of setting values will appear.
Use the 7 and 6 buttons to select EXECUTE from the list and
then press the SET button.
● The erasing of data will begin.
The message "DISC ERASE" appears and the state of progress is displayed
using a progress bar.
● When all data has been erased, the progress bar will disappear.
CAUTION
● All of the data recorded to the disc will be erased in this process. Before
starting, therefore, confirm that no important data is stored on this disc.
● Under no circumstances should the power be turned off or the power cord
disconnected while data is being erased.
Recording operations