JVC BD-X200E Instrucciones página 73

Network Settings
Use the following procedure to carry out network settings on both the sender and receiver devices.
BUSY
Cursor buttons
OPEN/CLOSE
(6, 7, t and 8)
OPTION DV Y/C LINE
SET UP
SET UP button
SET
TOP
MENU MENU
SET button
NETWORK MENU Screen
NETWORK MENU
MENU
HOST NAME
IP ADDRESS SETTING
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
99.99.99.99.99
MAC ADDRESS
Setting example:
This value is different for each
device.
IP ADDRESSS 192.168.100.xxx
SUBNET MASK 255.255.255.000
All devices are set to the same network.
Parameter
HOST NAME The parameter is used to enter the BD-X200's network name using a keyboard.
(Names may be up to 20 characters in length.)
IP ADDRESS This parameter cannot be set and is fixed in STATIC mode.
SETTING
IP ADDRESS Use this parameter to set the IP address. Make sure, however, that no two devices
on a single network share the same IP address.
SUBNET MASK Use this parameter to set the subnet mask. Connected BD-X200s should have the
same network setting.
DEAULT GATEWAY Use this parameter to set the gateway address. Connected BD-X200s should have
the same address.
1.
Press the SET UP button to display the Setup Menu.
2.
Select NETWORK from the Setup Menu and then press the SET
button.
● The NETWORK MENU screen will appear.
3.
Use the following parameters from the NETWORK MENU screen
to make settings required for dubbing.
HOST NAME
Use the 6 and 7 cursor buttons or the ∞ and √ arrow keys to select this
parameter, and then input the BD-X200's network name using the USB
keyboard.
(Names may be up to 20 characters in length.)
IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY
Refer to the following table for more details regarding these parameters.
bdx200
q Select the required parameter using the 6 and 7 cursor buttons or the
STATIC
192.168.0.2
w Select the digit to be set using the t and 8 cursor buttons or the †
255..255.255.0
192.168.0.254
e Change the selected digit using the 6 and 7 cursor buttons or the ∞
r Repeat steps w through e to make all of the required settings, and
4.
To return to the Setup Menu after all settings have been made,
select MENU from the NETWORK screen, and then press the SET
button or the ENTER key.
5.
Press the SET UP button to return to the normal screen display.
∞ and √ arrow keys.
and © arrow keys.
and √ arrow keys.
then press the SET button or Enter key.
Description Default setting
bdx200
————
192.168.000.002
255.255.255.000
192.168.000.254
E-71