Recording Video & Audio From A Non-Linear Editor - JVC BD-X200E Instrucciones

Synchronous Recording
Recording Video & Audio From a Non-Linear Editor
By connecting a non-linear editor featuring a DV terminal to this DVD recorder, audio and video processed using the editor can be
easily recorded to a disc. In this case, the BD-X200 will be controlled by commands from the non-linear editor, and these commands
will be communicated via the DV terminal.
Signal Connections
Rear panel
DV IN/OUT terminal
● Connect the DV IN/OUT terminal on the rear of your BD-X200 to the DV terminal on the non-linear editor using a DV (IEEE1394)
cable. One of the commercially-available cables indicated above should be used for this purpose.
● Connect the DVD recorder's VIDEO LINE OUT and AUDIO OUT terminals to the monitor's video in and audio in terminals.
Setup Procedures
● Insert a recordable disc into your BD-X200.
Settings
BD-X200 : Set REMOTE SELECT from the REMOTE MENU screen to DV (SLAVE).
REMOTE MENU screen
REMOTE MENU
MENU
REMOTE SELECT
REC CONTROL
REM FF/REW MODE
Note
When pressing and holding the REC
button more than 2 seconds while the DVD
recorder is stopped, encoded output
images can be checked while the button
is being held.
E-64
AUDIO OUT
VIDEO OUT
VIDEO AUDIO
IN LINE OUT INPUT CH1
LEVEL
IN OUT
4dB
8dB
Y/C
IN
CH2
REMOTE
DV IN/OUT
USB
LAN
SIGNAL
DC 19V
GND
(video, audio, and control signals)
DV cables:
VC-VDV204 (2 m, 4P-4P) from JVC
VC-VDV206 (2 m, 4P-6P) from JVC
● When REMOTE SELECT is set to DV (SLAVE), the REMOTE CONTROL (DV
SLAVE) screen will appear. This screen can be used to set editing points and
chapter marks. Refer to page 65 for details regarding usage of the REMOTE
CONTROL (DV SLAVE) screen.
DV(SLAVE)
OFF
FF/REW
Monitor
DV terminal
REMOTE CONTROL (DV SLAVE) screen
REMOTE CONTROL SCREEN ( DV SLAVE )
00:00:00:00
EXIT IN POINT
: : : : : :
h m s f h m s
1 00:00:00:00 2 00:15:00:00
4 00:25:00:00 5 00:30:00:00
7 00:40:00:00 8 00:45:00:00
TC INPUT
CHAPTER MANUAL
ADJ
BITRATE 8.0 Mbps DISC REMAIN
EDL LOAD
TC CANCEL
Non-linear editor
OUT POINT 00:10:00:00
: : :
f h m s f
3 00:20:00:00
6 00:35:00:00
9 00:50:00:00
: : :
000 min
FINALIZE