Product Specifications; G U I Da N Ce A N D Ma N U Factu Re R 'S D Ecl A Ratio N - SybronEndo Apex ID Instrucciones De Uso

12
CAUTION Do not use the Apex ID when wet
Rx ONLY
with ethanol. There is a possibility of electric shock
Keep Type B Caution This Stack 12
Dry Applied For Dental Side Up Maximum
Part Use Only
or product damage.
7.6 – Operating, Storage, Transport
The Apex ID should be operated in temperatures ranging
from 10~40°C, atmospheric pressure 70~106 Kpa
and relative humidity 30~75%. The Apex ID should be
stored and transported in temperatures ranging from
8 – TRO U BL E SH OOTI NG
If any problems occur, refer to the table below. If there are any further problems or issues please contact your distributor
or SybronEndo.
Problem
No power
No power
No buzzer sound
Power ON, but no measurements
show
Power ON, but not measured
9 – PRO DU CT SPE CI F ICATI O NS
• Rated voltage: DC4.5V (1.5V Alkaline Battery AAA x 3EA)
• Input current: less than DC 60mA
• Power consumption: less than 0.27VA
• Patient auxiliary current: less than AC 10µA
• Oscillation frequency: 500Hz ±0.2Hz, 5kHz ±0.002kHz
• Size: W70mm ±1mm x D25mm ±1mm x H100mm
±1mm
10 – G U I DA N CE A N D MA N U FACTU RE R 'S D ECL A RATIO N
The Apex ID is intended for use in the electromagnetic environment specified below. The customer or the user of the
Apex ID should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Possible Causes
Low Battery / No Battery
Battery replacement does not solve
the problem
No sound setting
Probe cord disconnected from the
main unit
File holder disconnected from Probe
cord
Guidance and manufacturer's declaration – electromagnetic emissions
Compliance Electromagnetic environment - guidance
Group 1 The Apex ID uses RF energy only for its internal functions. Therefore, its
RF emissions are very low and are not likely to cause any interference in
nearby electronic equipment.
Class A The Apex ID is suitable for use in all establishments including domestic and
those directly connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
-20~50°C, atmospheric pressure 70~106 Kpa and relative
humidity 5~90%.
7.7 – Disposal
Dispose of the product in accordance with your local
waste disposal regulations and/or laws
Solutions
Replace the batteries
Check the connection to the batteries
Adjust the buzzer volume
Check the connection of Probe cord
and the main unit
Check the connection of file holder
and Probe cord
• Weight: 390g ±15g (including stand, except battery)
• Protection type and level against electric shock: Type B
applied part
• Internally powered equipment, Ordinary equipment
(IPX0)
• Continuous operation time: 62hours (at 1250mAh
Battery x 3EA)
10
10/7/15 12:12 PM