en
10 | BAT 125 | Maintenance & Troubleshooting
5.
Maintenance & Trouble-
shooting
5.1
Cleaning
The housing and the display of the BAT 125 may only be
cleaned using soft cloths and neutral cleaning agents.
Do not use any abrasive cleaners or coarse workshop
cleaning rags.
5.2
Service Parts / Parts Subject to Wear
Designation
Connecting cable with terminals for the
battery
<)
Printer paper
(1 roll)
<)
(Minimum order 5 rolls)
wearing part
<)
|
1 689 989 125
2013-09-09
5.3
i
The integrated printer only uses thermal paper in a
roll with the dimensions 57 mm x 25.9 mm.
1. Unlock the printer door gently but firmly lifting up on
the release lever.
2. Remove the empty paper roll hub.
Ordering number
1 684 465 624
1 681 420 028
Fig. 2:
1 Paper Compartment
2 Paper Sensor
3 Release Lever
3. Place a new roll of paper in the compartment.
4. Pull the paper forward so that it extends past the
serrated edge of the paper slot.
Fig. 3:
5. Close the door and make sure the lever locks securely.
Changing the Printer Paper
Printer view
Paper feeds from underneath the roll
Robert Bosch GmbH