Prebena PKT-2-J50 SD Manual De Instrucciones Original página 96

Using the tool
 Observe the indication on the pressure gauge for the working
pressure (1).
 Press the regulator for the working pressure (3) to the left against
the handle until it engages audibly and tangibly.
The regulator for the working pressure is now locked.
The desired working pressure is now set.

When operating with a compressed air hose, you can set the
working pressure at the tool only as high as the output
pressure of the compressor.
Set nailing depth at adjustment wheel of firing protection device
You can also set the nailing depth of the fasteners in the wood by
turning the adjustment wheel of the firing protection device.
You will finding the following symbol on the cover of the tool:
34