Other Malfunctions; Troubleshooting Chart - Prebena PKT-2-J50 SD Manual De Instrucciones Original

 Connect the compressed air supply (see page 18).
 Check the function of the tool (see page 30).
Should you be unable to remedy the malfunction, contact your dealer
or the manufacturer (see page 58).

Other malfunctions

If malfunctions occur in the tool that cannot be remedied by cleaning
and oiling, please contact PREBENA Service.
 Do not carry out repairs to the tool yourself.
 Ensure that all malfunctions in the tool are remedied by
PREBENA Service.

Troubleshooting chart

The following chart shows possible malfunctions and the necessary
measures.
Symptom
Tool loses air.
Working pressure too
high (pointer of pressure
gauge over 10 bar).
Possible cause
The attachment
screws are loose.
A seal is defective.
Working pressure set
too high or tool
damaged.
Malfunctions
Remedy
 Tighten attachment
screws.
 Contact Service (see
page 58).
 Reduce working pressure
(see page 33).
If the problem continues to
exist:
 Disconnect the tool
immediately from the
compressed air supply
(see page 40).
Contact Service (see
page 58).
49