Use With A Weight Balancer - Prebena PKT-2-J50 SD Manual De Instrucciones Original

Use with a weight balancer

You can use the tool with a weight balancer. In order to attach the
rope of the weight balancer to the tool, a hanger loop has to be
attached to the housing head. Proceed as follows:
 Remove the compressed air cartridge or compressed air hose
from the tool (see page 40).
 Empty the magazine (see page 41).
 Loosen and remove the two rear hex. socket head screws (1) on
the housing head.
 Position the hanger loop (2) as illustrated below.
 Attach the hanger lop (2) with the hex. socket head screws (1).
The hander loop is now ready for use.
 Check the condition of the tool (see page 17).
The hanger loop (Article No. ET 42008001) can be obtained as an
accessory from PREBENA.
Preparing the tool
29