Removing The Transport Protection - Amann Girrbach Therm DRS Modo De Empleo

I N S T A L L A T I O N
WARNING:
E N
The mains cable may not be damaged!
▷ Do not place objects on the mains cable.
▷ Lay the mains cable in such a manner that
nobody can step on or trip over it.
▷ Pay attention that the cable does not have
contact with hot objects or surfaces.
▷ In case of damage to the insulation: Replace
the mains cable.
▷ Set the mains switch to the 0 position.
▷ Connect the enclosed mains cable to the socket
intended for this purpose on the rear of the fur-
nace.
Fig. 8 Electrical connection
▷ Connect the other end of the cable to the socket
outlet with earthing contact.
The mains cable may only be replaced
against an original mains cable from the
manufacturer.
36
5.2.2 Connecting the operating display
CAUTION:
Possible damage to the display!
The top surface of the furnace becomes very hot
during operation.
▷ Never place the display on the furnace.
▷ Connect the USB C cable to the ports on the rear
side of the operating display and the rear side of
the furnace ([6] in figure 2).
5.3

Removing the transport protection

▷ Switch the furnace on via the main switch.
▷ Open the furnace door by pressing button
the display.
▷ Carefully pull off the transport protection from
the sinter base to the front.
Fig. 9 Removing the transport protection
▷ Shut furnace door by pressing button
display.
on
on the