Attaching The Cylinder Wire Retainer; Installing The Cylinder Support Bracket; Securing The Front Shelf Brackets; Installing The Front Shelf - Pit Boss Pro PB1100PSC2 Manual Del Usuario

12. ATTACHING THE CYLINDER WIRE RETAINER

Parts Required:
1 x LP Gas Cylinder Wire Retainer (#37)
Installation:
• Remove the R-clip from LP Gas Cylinder Wire Retainer. Attach the LP
Gas Cylinder Wire Retainer to the right Support Legs. Use R-clip to
secure the wire retainer in place.

13. INSTALLING THE CYLINDER SUPPORT BRACKET

Parts Required:
1 x LP Gas Cylinder Support Bracket (#38)
3 x Screw (#A)
3 x Locking Washer (#C)
3 x Washer (#B)
Installation:
• Secure the LP Gas Cylinder Support Bracket to the cart bottom shelf
using three screws, locking washers, and washers.

14. SECURING THE FRONT SHELF BRACKETS

Parts Required:
1 x Front Shelf Bracket /L (#25)
1 x Front Shelf Bracket /R (#26)
6 x Screw (#A)
Installation:
• Attach one Front Shelf Bracket to the front of the Main Barrel by using
three screws. Install each screw half-way, then tighten completely
when all three screws are mounted and aligned properly. Repeat the
same installation for the other Front Shelf Bracket.

15. INSTALLING THE FRONT SHELF

Parts Required:
1 x Front Shelf (#27)
2 x Screw (#H)
2 x Washer (#B)
2 x Bushing (#D)
2 x Nut (#I)
Installation:
• From underneath, insert the screw (from the outside) into the Front
Shelf Bracket and the Front Shelf, then add the bushing onto the
screw, the washer, then the nut. Repeat the installation for the other
side of the front shelf.
NOTE: When installed correctly, the front shelf can be raised (for use)
and lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.
14
12
37
13
38
B
C
14
25
A
15
A
26
A
27
H