Error Table Unidrive - Storz UNIDRIVE S III Serie Manual Del Usuario

80
Technische Beschreibung
Error message
E01 MEMORY ERROR
E02 MOTORBOARD DEFECTIVE
E03 HARDWARE CONFIGURATION ERROR
E04 SOFTWARE CONFIGURATION ERROR
E05 -
E06 -
E07 -
E08 -
E09 MOTOR DEFECTIVE M1
E10 MOTOR DEFECTIVE M2
E11 NO FOOTSWITCH
E12 NO MOTOR
E13 TOO HIGH TEMPERATURE MOTOR
M1
E14 -
E15 TOO HIGH TEMPERATURE MOTOR
M2
E16 IRRIGATION PUMP NOT CLOSED
E17 MOTOR NOT SUPPORTED M1
E18 MOTOR NOT SUPPORTED M2
E19 MOTOR STOPPED M1
E20 MOTOR STOPPED M2
E11 NO SCB MODULE
Technical description

10. 2 Error table UNIDRIVE

®
Cause
Parameters could not be saved successfully
Motor control overloaded
Hardware configuration is incorrect
Software configuration is incorrect
Motor on channel 1 is defective
Motor on channel 2 is defective
Footswitch not connected correctly
No motor or handpiece connected
Motor or handpiece on channel 1 overheated
Motor or handpiece on channel 2 overheated
Pump lever not connected correctly
The motor or handpiece connected on channel 1
is not supported.
The motor or handpiece connected on channel 2
is not supported.
Motor or handpiece on channel 1 blocked in ope-
ration
Motor or handpiece on channel 1 blocked in ope-
ration
Unit is not connected to an active SCB bus
Descripciones técnicas
Troubleshooting
Turn device on/off. Load default values. Or send unit
in for repair.
Turn device on/off. Or send unit in for repair.
Send unit in for repair.
Send unit in for repair.
Release footswitch and restart. If the error persists, a
different handpiece must be used.
See E09
Connect footswitch.
If the error persists, check whether the error is on the
footswitch or device. Send the defective component
in for repair.
Allow the connected handpiece to cool down or
operate an additional handpiece on the 2nd channel.
See E13
Set pump lever vertically. If the error persists, the
device must be sent in for repair.
Only use ones approved by KARL STORZ. An
update by Service may be necessary.
See E17
Release footswitch and restart. If the error persists,
clean the handpiece or exchange the attachment.
See E19
Insert SCB cable and activate SCB bus.