¡ Your changes to the basic settings will be retained
even after a power failure. Only the settings pertain-
ing to the initial start-up of the appliance need to be
implemented once again following a power failure.
→ "Initial use", Page 39
Basic settings Selection
Language
Set "Language"
Time
Set "Time "
Date
Set "Date"
Audible signal
Short cooking time
Medium cooking time
Long cooking time
Button tone
Switched off
Switched on
Display bright-
The display brightness can be adjus-
ness
ted in 5 settings
Setting 3
Clock display
Digital + date
Digital
1
Off
Factory setting (may vary according to model)
1
14 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
14.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
New sponge cloths contain residues from production.
Wash new sponge cloths thoroughly before use.
▶
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
1
1
1
Basic settings Selection
Night-time dim-
Switched off
ming
Switched on (display dimmed
between 10 p.m. and 6 a.m.)
Demo mode
Switched off
Switched on (this is only displayed in
the first 3 minutes following a reset
or the initial start-up)
Factory set-
Reset
tings
Do not reset
1
Factory setting (may vary according to model)
Note: Changes to the language, button tone and dis-
play brightness settings take effect immediately. All
other settings do not take effect until you save them.
13.3 Changing the time
Press
.
1.
Press
.
2.
a The operating modes menu opens.
Use the rotary selector to select "Settings".
3.
Use
to navigate to "Time ".
4.
Use the rotary selector to change the time.
5.
Press
.
6.
Select "Save" to save the setting.
7.
14.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
WARNING ‒ Risk of fire!
Loose food remnants, fat and meat juices may catch
fire.
Before using the appliance, remove the worst of the
▶
food residues and remnants from the cooking com-
partment, heating elements and accessories.
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or sharp
▶
metal scrapers to clean the glass on the appliance
door, as they may scratch the surface.
Read the information on cleaning products.
1.
→ Page 45
2.
Observe the information on cleaning the appliance
components or surfaces.
Unless otherwise specified:
3.
Clean the components of the appliance with hot
‒
soapy water and a dish cloth.
Cleaning and servicing en
1
1
1
45