Performing Initial Settings - Canon CS100 Manual De Instrucciones

Power Lamp Indicators

Power button/Power lamp
Do not lift or move Connect Station when its power is on or it is standing by. Dropping

Connect Station or hitting it against an object may damage its hard disk.
Disconnecting the power cord or DC plug when the power to Connect Station is on or

Connect Station is standing by can lead to a malfunction. Before disconnecting the
power cord or DC plug, check that the power lamp is off.
Before turning on the power, check that no card is inserted and that no camera/

camcorder is connected to the USB terminal.
If the power lamp is blinking in red, turn on Connect Station and check the TV screen to

see the content of the error (p.28). If you cannot turn on Connect Station when the
power lamp is blinking in red, contact the nearest Canon Service Center.
Even if it is standing by, Connect Station consumes as much power as it does when its

power is on (p.78).

Performing Initial Settings

Perform the Connect Station operations as described below while looking at the TV
screen and using the Connect Station remote control.
When Connect Station is connected via a wired LAN (p.16), the screens shown in

steps 3 and 4 will not be displayed.
Connect
Station Status
Power on
Power off
Standby
Updating the firmware Green (blinking)
Error
Press <S>.
1
Select the language.
2
Press the <T> key to select the

language, then press <S>.
Depending on the selected

language, a screen may appear
prompting you to select your
country or region. Select an area
first, then select a country or region.
Power Lamp
Indicator
Green (lamp on)
(Lamp off)
Orange (lamp on)
Red (blinking)
17