Canon CS100 Manual De Instrucciones página 21

4-B
[Find network]
Before establishing a connection, ensure you have the following information
• Access point name (SSID)
• Encryption key (password) specified for the access point
* For information on the access point name (SSID) and encryption key (password), refer to the
access point's instruction manual.
If you select [Skip Wi-Fi settings], reconnect to another access point, or connect

using WPS (PIN code), you can make the settings later in [Preferences] (p.69).
If the access point cannot be detected within two minutes after you select [WPS Push

button connection (PBC)], an error message appears. In that case, check that the
access point supports WPS and try again, or select [Find network] to establish the
connection.
If the network you use filters by MAC address, register the MAC address of Connect

Station at the access point. The MAC address is indicated on the bottom of Connect
Station.
If the response of the remote control is slow when selecting characters or images,

operate the remote control slowly.
(1) Select the access point
name (SSID) to connect to.
Press the <h> <g> keys to select

the access point name (SSID) of
the [Peripherals found], then
press <S>.
When [Enter manually] is

selected, enter the access point
name (SSID) in the input screen.
(2) Enter the encryption key
(password).
Select a character with the <T>

keys, then press <S> to enter
it.
When you are finished, select

[OK], then press <S>. Wait
until the connection is complete.
This screen is not displayed when

you connect to an unencrypted
access point.
 When the connection is complete,
the [Set date/time] screen will
appear.
*
:
19