Canon CS100 Manual De Instrucciones página 74

[Delete all images on system]
Delete all images imported to Connect Station.
[Format system hard disk]
Delete all images imported to Connect Station as well as all its settings.
When you perform [Format system hard disk], all the images imported to

Connect Station will be deleted. Even protected images will be deleted, so make
sure there is nothing you need to keep. Back up the necessary recorded data
before executing formatting.
When formatting the hard disk to transfer or dispose Connect Station, see "Disposal

and Transfer of the Product" (p.9).
Do not remove or insert a card or USB cable during formatting or firmware update.

If an error occurs while the system hard disk is formatted, the hard disk may be

damaged. In such a case, contact the nearest Canon Service Center.
72
Protected images will not be

deleted.
Once an image is deleted, it

cannot be recovered. Backing up
images before deleting them is
recommended.
When you press <M>, the

deletion will start.
When you press <M>, the

formatting will start.
The normal formatting cannot

delete all the data on Connect
Station's hard disk. To delete the
data completely, press <S> to
append [z] for [Low-level
format], then execute formatting.
When the formatting is complete,

Connect Station will restart.
The standard time it takes for

formatting is as follows.
• Normal formatting: Approx. 1
minute
• Low-level formatting: Approx.
10 hours