Compatible Cards - Canon CS100 Manual De Instrucciones

When holding the camera/camcorder close to Connect Station, do not drop the

camera/camcorder on it or push the camera/camcorder hard against it. Doing so may
damage the built-in hard disk.
While images are being imported, you cannot connect an NFC-compatible camera/

camcorder even if you hold it close to Connect Station.
If a case etc. is attached to the camera/camcorder, connection may not be possible. In

such a case, detach the case etc., and hold the camera/camcorder close to Connect
Station.
Since the camera/camcorder may not be recognized readily, carefully hold the camera/

camcorder close to the NFC connect point on Connect Station while rotating the
camera/camcorder horizontally.
Just holding the camera/camcorder close to Connect Station may not establish a

connection. In such a case, gently touch Connect Station with the camera/camcorder.
When connecting Connect Station to a camera/camcorder, and it gives three short

beeps and the power lamp blinks in red, this indicates that Connect Station is not in a
status to establish connection. Make sure if the camera/camcorder is ready for
connection.
If the camera/camcorder and Connect Station are moved too far away from each other

while importing images, the import may take time or the connection may be terminated.
If the camera's/camcorder's battery runs out during import, the import will stop. Charge

the battery, then try importing again.
While a wireless LAN connection is established, you may not be able to connect a

camera/camcorder even if you connect it with an interface cable.
You may not be able to connect a certain NFC-compatible camera/camcorder with low

battery level to Connect Station, even when you hold it close to Connect Station. In
such a case, recharge the battery, then hold the camera/camcorder close to Connect
Station.
The power to some cameras/camcorders may be turned on when you hold the

camera's/camcorder's n close to Connect Station.
When all images are already imported, import does not start.

Importing from a Card

Import images by inserting a card storing captured images into Connect Station.
Images can be imported from a card used for shooting with Canon compact digital

cameras, digital single-lens reflex cameras, compact system (mirrorless)
cameras, or digital camcorders released in 2010 or later. Although images may be
imported from a card used in other cameras, there is no guarantee for the import
of images to Connect Station.

Compatible cards

The following cards can be used when importing images from a card.
SD/SDHC/SDXC memory card

CF (Compact Flash) card

* The CFast card is not supported.
23