Canon CS100 Manual De Instrucciones página 44

NFC connect point
When holding the terminal close to Connect Station, do not drop the terminal on it or

push the terminal hard against it. Doing so may damage the built-in hard disk.
If a case etc. is attached to the terminal, connection may not be possible. In such a

case, detach the case, etc., and hold the terminal close to Connect Station.
Since the terminal may not be recognized readily, carefully hold the terminal close to

the NFC connect point on Connect Station while rotating the terminal horizontally.
Just holding the terminal close to Connect Station may not establish a connection. In

such a case, gently touch Connect Station with the terminal.
When Connect Station gives three short beeps and the power lamp blinks in red, check

whether Connect Station is connected to the access point, router, etc.
42
Operate the terminal to
1
connect to the access point,
router, etc. to which Connect
Station is connected.
Hold the terminal close to the
2
NFC connect point on Connect
Station.
Carefully hold the n on the

terminal close to the NFC connect
point on Connect Station.

Connect Station gives two short
beeps, and the Wi-Fi lamp blinks
twice. If the browser on the
terminal starts and the login
screen is displayed,
communication is established via
Wi-Fi even if the terminal is
moved away from Connect
Station.
Operate the terminal to log in
3
to Connect Station.
On the terminal screen, select

[OK].
 The album list screen will appear
(p.44).