Compatible Cameras/Camcorders - Canon CS100 Manual De Instrucciones

Importing via a Wired Connection (USB Terminal)

Import images by connecting Connect Station to a camera/camcorder with an
interface cable (USB cable). For information on the interface cable, refer to the
Camera/Camcorder Instruction Manual.

Compatible cameras/camcorders

Cameras/camcorders from which images can be imported via a wired connection are
Canon compact digital cameras, digital single-lens reflex cameras, compact system
(mirrorless) cameras, and digital camcorders released in 2010 or later. Although
cameras/camcorders other than these may be connected via a wired connection,
there is no guarantee for the import of images to Connect Station.
When connecting or disconnecting the cable, hold Connect Station in place. When

disconnecting the cable, be sure to hold the plug; do not pull the cable.
When connecting the cable to Connect Station, do not lift or move Connect Station with

its power on. Dropping Connect Station or hitting it against an object may damage its
hard disk.
If you connect a camera/camcorder or insert a card and the import of images does not

start even when there are images that have not been imported yet, disconnect the
camera/camcorder, remove the card, restart Connect Station, then try again.
When connecting to a camera/camcorder, use fully-charged batteries.

Images cannot be imported to Connect Station from a USB charging-compatible

camera/camcorder by connecting them with an interface cable.
Do not connect a USB cable or insert a card while the Connect Station's hard disk is

being formatted or its firmware is being updated.
Movie files exceeding 4 GB in file size shot with the EOS-1D X Mark II cannot be

imported via a wired connection. Import them from the card (p.23).
Images can be imported even when Connect Station is standing by (p.16).

When all images are already imported, import does not start.

Importing images
Use the interface cable that you

use to connect a camera/
camcorder to a computer.
Connect the USB terminal on

Connect Station to a camera/
camcorder, then turn on the
camera's/camcorder's power.
 The access lamp will blink, and
the import of images will start.
The import is complete when the

access lamp stops blinking and
stays lit. Turn off the camera's/
camcorder's power, then
disconnect the cable.
25