Canon CS100 Manual De Instrucciones página 81

Wi-Fi (Wireless LAN) / NFC Precautions
Model: CS100 systems
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
Note:This equipment has been tested and
found to comply with the limits for class
B digital devices, pursuant to Part 15 of
the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between
the equipment and receiver.
— Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
The cable with the ferrite core provided with
this device must be used with this equipment
in order to comply with Class B limits in
Subpart B of Part 15 of the FCC rules.
Do not make any changes or modifications to
the equipment unless otherwise specified in
the manual. If such changes or modifications
should be made, you could be required to
stop operation of the equipment.
Canon U.S.A. Inc.
One Canon Park, Melville, NY 11747, U.S.A.
Tel No. 1-800-OK-CANON (1-800-652-2666)
CAN ICES-3 (B) / NMB-3 (B)
Countries and Regions Permitting
wireless LAN/NFC Use
Use of wireless LAN/NFC is restricted in
some countries and regions, and illegal use
may be punishable under national or local
regulations. To avoid violating wireless LAN/
NFC regulations, contact the nearest Canon
Service Center.
Note that Canon cannot be held liable for any
problems arising from wireless LAN/NFC use
in other countries and regions.
Model Number
CS100: DS586021
(including WLAN module model: AW-NU173)
(including NFC module model: CH9-1372)
FCC/IC NOTICE
Model: CS100 (including WLAN Module
Model AW-NU173, FCC ID: VUI-CMST173/
IC: 7582A-CMST173, NFC module model:
CH9-1372 FCC ID: AZD226/ IC: 498J-226)
This device complies with Part 15 of FCC
Rules and Industry Canada's licence-exempt
RSSs. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter except Canon accessories
supplied or designated for this product.
This equipment complies with FCC/IC
radiation exposure limits set forth for an
uncontrolled environment and meets the
FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the IC radio
frequency (RF) Exposure rules. This
equipment should be installed and operated
keeping the radiator at least 20cm or more
away from person's body.
Hereby, Canon Inc., declares that this
CS100, CH9-1372 is in compliance with the
essential requirements and other relevant
provisions of Directive 1999/5/EC.
Please contact the following address for the
original Declaration of Conformity:
CANON EUROPA N.V.
Bovenkerkerweg 59, 1185 XB
Amstelveen, The Netherlands
CANON INC.
30-2, Shimomaruko 3-chome,
Ohta-ku, Tokyo 146-8501, Japan
79