Inserting A Card - Canon CS100 Manual De Instrucciones

SD card
CF card
Importing images
Insert a card into the card slot.

 The access lamp will blink, and the import of images will start.
The import is complete when the access lamp stops blinking and stays lit. Remove

the card.
Connect Station is importing, copying, or backing up images when its access

lamp (green) is blinking. Do not do any of the following when the access lamp is
blinking; doing so may destroy image data or damage Connect Station, card, or
connected device.
• Disconnecting the USB cable.
• Removing the card.
• Unplugging the power cord.
When inserting or removing the card, hold Connect Station in place.

Be careful not to lose the card slot cover. Make sure the card slot is covered when not

in use.
When all images are already imported, import does not start.
24
Access lamp (green)

Inserting a card

Remove the card slot cover in

advance.
Insert an SD card with its front

side facing upward until it
clicks in place.
Insert a CF card with its front

side facing upward so that the
end where tiny holes are
aligned goes inside. Inserting
the card in the wrong direction
will damage Connect Station.
Removing a card
Check that the access lamp is

not blinking.
An SD card will be ejected when

you gently push it in and release
it.
In the case of a CF card, pull it

out slowly.