Franke CM 65 M Manual De Instalación Y Servicio página 11

Confirm by pressing the right knob again.
X X
The data can also be automatically acquired by
X X
allowing the blinking to continue for 10 seconds.
The LEDs for symbols
„ „
remain lit and the oven will switch on at the set
time, when only the LED for the symbol
will remain lit.
At the end of cooking, the ringer will sound
„ „
for 1 minute; this sound can be stopped by
pressing the right knob.
Setting the time of day
To set the correct time, just press the right knob
X X
three times (the LED for the clock symbol starts
blinking), then turn the left knob.
After setting the right time, press the right knob
X X
to confirm.
Electronic cooking programmer
It enables oven programming in the following modes:
– delayed start of cooking with set duration,
– immediate start of cooking with set duration;
– timer.
Setting the digital clock
When the appliance has been connected to the
mains or after a power failure the display will
flash on: „0.00".
Press the + and - buttons
X X
together for a few
seconds. The time of day
can be adjusted with the
+ and - buttons, while the
dot between the hours
and minutes flashes.
If the time setting mode is selected when an
„ „
automatic programme is active, the automatic
programme is cancelled.
Possible time adjustments can be made by repeating
the steps described above.
Acoustic signal frequency modification
The frequency of
the acoustic signal
can be changed if a
cooking cycle is not
programmed (therefore
the display shows the
time of day).
and will
B
B
Press the + and - buttons (from the time
X X
modification menu) together.
Press Mode or Set to select the menu for
X X
modifying the acoustic signal frequency.
The acoustic signal frequency can be modified
X X
by repeatedly pressing the Mode or Set button;
„ton1", „ton2", „ton3" will appear on the display.
Manual oven operation
Once the time has been set, the programmer
automatically switches to manual mode.
Starting delayed cooking with set duration
When the time of the day is displayed, press the
X X
Mode or Set button twice to set a duration.
Then press it again to set the end of cooking
X X
time.
Set the required time with the + and - buttons.
X X
During duration or end time adjustment mode
„ „
selection, the Auto symbol remains lit.
Once a programme duration is set, the end
„ „
time cannot be decreased.
Likewise, the duration of a programme cannot
„ „
be prolonged once the end time is set.
The end time and duration settings define
„ „
programme start time as follows:
start time = end time - duration.
After setting the duration and end time, the
„ „
display still shows the end time.
The programme starts when the time of day
„ „
coincides with the start time: the Auto symbol
lights up steadily and the symbol
flashing.
After the start of cooking, the display shows
„ „
the countdown. If only the end of cooking time
is selected (the duration is = 0), cooking starts
and the display shows the countdown.
The Auto symbol remains lit during the wait
„ „
for delayed start and for the entire duration of
cooking.
The symbol
„ „
delayed start and remains fixed when cooking
starts.
An acoustic signal sounds at the end of
„ „
cooking; to silence it, press any button or allow
the signal to continue for its duration.
– 11 –
starts
flashes during the wait for
EN