Connection Panel - Pioneer PDP-5004 Manual De Instrucciones

Connection Panel

Illustration depicts PDP-5004, PDP-5014, PDP-4304
and PDP-4314 models.
S-VIDEO
0
SPEAKER
R
8Ω ~16Ω
+ –
1
Plasma Display Section
The plasma display is provided with 5 video input
connectors, 1 video output connector, audio input jacks and
speaker terminals.
For instructions regarding connections, consult the pages
noted in parentheses by each item.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 –16 Ω.
2
RS-232 Terminal (used in the factory setup)
3
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD recorder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 13 to 14).
4
AUDIO (INPUT1) (RCA pin jack)
Use to obtain sound when INPUT1 is selected.
Connect this jack to the audio output connector of the
device connected to INPUT1 to this unit (page 17).
Note
The left audio channel (L) jack is not compatible with
monaural input sources.
INPUT3 INPUT4
AUDIO VIDEO AUDIO
R L IN OUT R L
- = ~ !
SERVICE ONLY
2
Part Names and Functions
POWER AC IN
OFF ON
7 8
COMPONENT
INPUT5
AUDIO
VIDEO
Y C /P C /P R L
B B R R
@ #
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
3 4
5
AUDIO (INPUT2) (RCA Pin jacks)
Use to obtain sound when INPUT2 (analog audio) is
selected.
Connect these jacks to the audio output connectors of
components connected to INPUT2 (page 17).
Note
The left audio channel (L) jack is not compatible with
monaural input sources.
6
HDMI (INPUT2) (HDMI jack)
For connection of components that have a digital
video output terminal such as a digital set top box,
DVD player, etc. compatible with HDCP . Before
attempting to connect one of these devices, read its
operating instructions to make sure that it can be
connected (page 15).
(HDCP = High-bandwidth Digital Content Protection)
(HDMI = High Definition Multimedia Interface)
7
MAIN POWER switch
Use to switch the main power of the plasma display
on and off.
8
AC IN
A power cable is furnished with the plasma display;
connect one end of the power cable to this connector,
and the other end to a standard AC power source.
SPEAKER L
8Ω ~16Ω
+ –
9
AUDIO
INPUT2
R L
HDMI
5 6
9
EN