Returning To The Original Picture Adjustment Values - Pioneer PDP-5004 Manual De Instrucciones

Picture and Screen Adjustment
COLOR TEMP .
Sets white color tone as desired.
Each time you press the 2/3 buttons, the setting
changes as follows:
3 LOW 2 3 MID 2
¶ LOW ......... Provides yellowish color tone with low
warmth.
¶ MID ......... Provides natural color tone (Standard).
¶ HIGH ......... Provides a bluish, very warm color tone.
¶ Adjustment items during PC signal input
Decrease
CONTRAST ..... Contrast becomes weaker
BRIGHTNESS ... Picture becomes darker
Returning to the Original Picture
Adjustment Values
Returning adjusted values to the initial values at the time
of shipment from the factory.
Note
This setting is not possible when in the DYNAMIC mode in [AV
SELECTION].
1
Select the INPUT and AV SELECTION mode for the
values you want to return to the initial factory
settings.
Remote control unit
32
EN
3 HIGH 2
Increase
Contrast becomes stronger
Picture becomes brighter
MENU
2/3
SET
5/∞
AV
SELECTION
2
Press the MENU button to display the menu.
STANDARD
PICTURE SCREEN
CONTRAST
BRIGHTNESS
COLOR
TINT
SHARPNESS
MPEG NR
DNR
CTI
COLOR TEMP.
PICTURE RESET
ENTER
SET
3
Use the 5/∞ buttons to select [PICTURE RESET],
then press the SET button.
STANDARD
PICTURE SCREEN
CONTRAST
BRIGHTNESS
COLOR
TINT
SHARPNESS
MPEG NR
DNR
CTI
COLOR TEMP.
PICTURE RESET
ENTER
SET
4 Use the 2/3 buttons to select [YES], then press
the SET button.
All the picture adjustment data for the currently
selected INPUT and AV SELECTION mode is reset to
the initial factory settings, and you return to the
display shown in step 3.
PICTURE RESET?
YES
SET
SET
5
After completing settings, press the MENU button
to return to the normal display.
Note
[PICTURE RESET] only applies to the currently selected INPUT
and AV SELECTION. It cannot be simultaneously applied to
multiple INPUTS and AV SELECTION settings.
INPUT1
SETUP OPTION
:
0
:
0
:
0
:
0
:
0
:
ON
:
MID
:
ON
:
MID
EXIT
MENU
INPUT1
SETUP OPTION
:
0
:
0
:
0
:
0
:
0
:
ON
:
MID
:
ON
: MID
EXIT
MENU
NO
EXIT
MENU