Fein Slugger JME HoleMaker III Instrucciones De Uso página 25

Feed (figure 15).
Work only with the absolutely required
amount of feed. Excessive feed can lead to
breakage of the application tool and loss of
the magnetic holding power.
To generate feed, turn the spoke handle man-
ually while the drill motor is switched on.
Mounting the spoke handle is described
under „Mounting the spoke handle".
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hands. Always use a chip hook
(6 42 98 160 40 0).
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Fig. 15
en
25