JVC BD-X200E Manual Del Usuario página 15

8
RS-422A REMOTE terminal (D-sub 9-pin male)
This terminal is used to connect the DVD recorder to a VCR
capable of being controlled via RS-422A.
● Select the control method of this terminal with the REMOTE
SELECT item on the REMOTE MENU screen.
9PIN(MASTER): This machine controls the VCR as
master.
9PIN(PLAY): Use this setting to use this machine as a
player.
9PIN(REC): This machine is a slave operated in
accordance with instructions from a non-
linear editor.
9
LAN terminal (RJ-45)
● When two DVD recorders are used to perform DVD-to-DVD
dubbing, this terminal is connected to both BD-X200s. A
cable of Category 5 or better is required for this connection.
A cross-type Ethernet cable is required when connecting
directly to another BD-X200.
● This terminal is also used when connecting to a PC on
which BD-X200 utility software for operations such as the
creation of the title and chapter menus has been installed.
● Network settings must be carried out using the NETWORK
MENU screen.
0
USB terminals (2)
These terminals are used when connecting the DVD recorder
to USB devices such as a keyboard or mouse.
A keyboard and mouse can be used as an alternative to the
DVD recorder's buttons when using setting and control
screens.
The input of text in setting screens is carried out using a
keyboard.
● It is not be possible to operate devices other than a keyboard
or mouse by connecting them to the USB terminal.
● Set KEYBOARD STYLE from the SYSTEM MENU screen
in accordance with the keyboard's input language.
Recommended manufacturers: Logitech
All manuals and user guides at all-guides.com
$
IN
LAN
SIGNAL
GND
9
#
!
@
#
$
VIDEO AUDIO
IN LINE OUT INPUT CH1
LEVEL
IN OUT
4dB
8dB
Y/C
CH2
REMOTE
DV IN/OUT
USB
DC 19V
0 @
DC IN terminal (2-pin)
This terminal is used to provide DC at 19 V to the DVD
recorder. The DC power cord from the AC adaptor (included)
should be connected here.
Note
When power is supplied via this terminal, the OPERATE
indicator on the front panel lights up in red.
DC power cord clamp
This clamp secures the DC power cord in place, and it should
always be used to prevent accidental disconnection.
SIGNAL GND terminal
This terminal is used to ground signals.
Optional-board slot cover
This cover is removed to allow commercially-available optional
boards to be installed.
8
!
E-13