Playback
Playing Back a Finalized Disc
This DVD recorder can also be used to playback discs that it has recorded and finalized.
When a disc is finalized, its title menu will be used to create the top menu.
The action taken by your BD-X200 when a disc it has finalized is inserted or when playback of a title has ended will depend on the
settings of DISC IN ACTION and TITLE END as set on the RECORDER MENU (2/2) screen during recording.
* Playback may not proceed smoothly with discs recorded using different devices, regardless of whether or not they have been
finalized.
Caution
● During playback of a disc, if the input setting
is DV then the sound can be delayed. In this
case, change the input setting to LINE or Y/
C.
● If the disc is dirty or damaged good playback
may not be possible. In this case either clean
the disc or change it.
1.
Insert a disc.
Depending upon the INTRODUCTION TITLE item and the DISC IN ACTION item settings of the RECORDER MENU (2/2)
screen during recording, the operation will differ. Operate in accordance with the table below. (For the operation with a disc
with a DVD MENU TYPE item set to NONE, refer to page 61.)
Set to OFF
The action set in the DISC IN ACTION item is carried out.
(See below.)
MENU
The title menu will appear
2.
Select the number of the title to be played.
Use the t, 8, 7, and 6 buttons to select the title number
for playback.
3.
Press the SET button to begin playback.
4.
Set to Still mode.
This is done by pressing the PAUSE button.
● The DVD recorder enters Still mode.
● If the PAUSE button is then pressed again in Still mode, the DVD recorder will advance playback by a single frame.
5.
Restart playback.
Press the PLAY button.
The DVD recorder will behave as follows when title playback has ended.
These actions will depend on the setting made for TITLE END from the RECORDER MENU (2/2) screen during recording.
Set to MENU
Enters stop mode and the
title menu (TOP MENU) is
displayed.
6.
Stop playback.
This is done by pressing the STOP button.
● The DVD recorder enters Stop mode.
E-60
All manuals and user guides at all-guides.com
OPERATE
CH1
CH2
PHONES
INTRODUCTION TITLE item setting during recording
DISC IN ACTION setting made during recording
TITLE END item setting during recording
Set to REPEAT
Repeats playback within
Enters the stop mode. The
the title.
title menu (TOP MENU) is
not displayed.
Note
When the introduction title (opening movie) is played on another DVD
player only the STOP button is accepted.
DVD RECORDER BD-X200
AUDIO
TITLE
CHAPTER
DOLBY DIGITAL
LPCM MPEG
REV
STOP
PLAY
FWD
PAUSE
REC
PAUSE button
STOP button
PLAY button
The introduction title (opening movie) is automatically played.
After playback is finished, the action set in the DISC IN ACTION
item is carried out. (See below.)
Playback starts automatically from the first title.
Set to STOP
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
SET UP
Cursor buttons
SET
TOP
MENU
MENU
(t, 8, 7, and 6)
SET button
Set to ON
TITLE
Set to NEXT TITLE
Next title is played. When playback
of the final title finished, the first title
is played. (Disc repeat playback)