Dvd Dubbing; Dubbing Dvds Using The Lan Terminal; Signal Connections - JVC BD-X200E Manual Del Usuario

DVD Dubbing

Dubbing DVDs Using the LAN Terminal

When the LAN terminal is used to join two BD-X200 DVD recorders via an Ethernet connection, audio and video from a sender
DVD can be dubbed onto a DVD on the receiver device.
Connected devices : One BD-X200 SENDER (used for playback of the master DVD)
One BD-X200 RECEIVER (used for DVD recording)

Signal Connections

All connection and disconnection of cables should be carried out with the power turned off.
Direct connection of two BD-X200s
Connect an Ethernet cable between the LAN terminals of the sender and receiver devices.
A Category 5, cross-wired Ethernet cable should be used in this case.
Sender BD-X200
LAN
LAN terminal
All manuals and user guides at all-guides.com
VIDEO AUDIO
IN LINE OUT INPUT CH1
LEVEL
IN OUT
4dB
8dB
Y/C
IN
CH2
REMOTE
DV IN/OUT
USB
SIGNAL
DC 19V
GND
CAT-5 cross-wired cable
Receiver BD-X200
VIDEO AUDIO
IN LINE OUT INPUT CH1
LEVEL
IN OUT
4dB
8dB
Y/C
IN
CH2
REMOTE
DV IN/OUT
USB
LAN
SIGNAL
DC 19V
GND
LAN terminal
E-79