Ryobi PPW-3000 Manual De Utilización página 30

GB
F D E I
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine fails to start 1. Engine switch is in the off position
2. No fuel in tank
3. Spark plug shorted or fouled
4. Spark plug is broken (cracked
5. Ignition lead wire shorted, broken,
6. Ignition inoperative
Engine hard to start 1. Water in petrol
2. Engine is under or over choked
3. Weak spark at spark plug
Engine lacks power 1. Dirty air filter
Detergent fails to mix 1. Detergent injection tube is not
with spray
2. High pressure nozzle attached
Pump doesn't 1. Low pressure nozzle installed
produce pressure 2. Inadequate water supply
3. Spray wand leaks
4. Nozzle is clogged
5. Pump is faulty
Machine doesn't 1. Diameter of garden hose is too
reach high pressure
2. Water supply is restricted
3. Not enough inlet water
4. Wrong nozzle is attached
All manuals and user guides at all-guides.com
P NL S DK N FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
porcelain or electrodes broken)
or disconnected from spark plug
fresh fuel.
properly submerged
small
and blockages.
CZ RU RO PL SLO HR TR EST LT
English
1. Move switch to start.
2. Fill tank.
3. Replace spark plug.
4. Replace spark plug.
5. Replace lead wire or attach to spark
plug.
6. Contact authorized service center.
1. Drain entire system and refill with
2. Adjust choke as necessary.
3. Contact authorized service center.
1. Clean or replace air filter
1. Insert detergent injection tube into
detergent storage bucket
2. Use low pressure nozzle (black) to
apply detergent.
1. Replace with high pressure nozzle.
2. Provide adequate water flow.
3. Replace wand.
4. Clean nozzle.
5. Contact authorized service center.
1. Replace with 20 mm. garden hose.
2. Check garden hose for kinks, leaks,
3. Open water source full force.
4. Attach the high pressure nozzle.
22
LV SK BG
SOLUTION