Battery Charger; Important - Grabo PRO-LIFTER 20 Manual Del Operador

Battery charger

Charging output voltage
Charging output current
Charging input
Rated power
Operating temperature
Storage temperature
Working conditions
GRABO® PRO-LIFTER 20 lifting capacity
NOTICE: The GRABO® Pro-Lifter 20 was tested up to 240 kg (530 lbs) at maximum lifting force
under ideal conditions. However, this figure is the breaking point under optimal lab testing
conditions and must never be reached in real-world applications!
Local regulations require different safety margins to be used and the official tool Working Load Limit
(WLL) is set to 120 kg (265 lbs) based on a 2:1 ratio on a non-porous surface. The Working Load Limit
of 120 kg (265 lbs) is one-half of the tested maximum lifting force under ideal conditions (240 kg/530
lbs) and should be adhered to when working in countries where the 2:1 safety margin applies,
regardless of the fact that the chart below shows a maximum lifting force of 170 kg (375 lbs). In no
case should the GRABO® Pro-Lifter 20 be used to lift more than 170 kg (375 lbs). Use the chart
below to estimate safe lifting values:
WLL: 120 kg (265 lbs) on non-porous surfaces
IMPORTANT: The lifting force is highly dependent on the lifted surface and factors such as
temperature, altitude (ambient pressure), and other factors.
Always check the pressure displayed on the GRABO® Pro-Lifter 20 LED display and do not rely
solely on the estimated maximum lifting forces chart when lifting different materials since
different factors related to your specific application may reduce lifting capabilities of the tool.
GRABO® PRO-LIFTER 20 | Operator's manual
16.8 V rated; 8 - 12 V under load
200 - 400 mA under load, 1.4 A max
100 - 240 V AC; 50/60 Hz; 1.5 A max.
23.52 W
0 °C ... +40 °C/+32 °F ... +105 °F
-20 °C ... +85 °C/-4 °F to +185 °F
Indoor use only; not waterproof (IP0)
11