Grabo PRO-LIFTER 20 Manual Del Operador página 21

EXPLANATION OF VISUAL INDICATORS
GRABO® Pro-Lifter 20
Signal
No light
Run status indicator is continuously red
Run status indicator flashes red
Run status indicator is continuously green
Bar indicator on display shows 5 green bars
Last bar of bar indicator on display flashes red
Bar indicator on display
Battery Charger
Signal
LED is continuously red
LED is continuously green
MAINTENANCE
WARNING: Changes to the tool and technical modifications are not permitted. This can lead to
injury. If the tool fails despite the care taken in manufacturing and testing procedures, repair shall be
carried out by an after-sales service centre for the GRABO® Pro-Lifter 20.
REPLACING THE RUBBER FOAM SEAL ❽
Remove the rubber foam seal if it has become worn or damaged.
1. Pull out the rubber foam seal Ⓘ .
2. Gently press a replacement rubber foam seal into position.
3. Make sure that the replacement rubber foam seal fits correctly and securely.
GRABO® PRO-LIFTER 20 | Operator's manual
Meaning
The GRABO® Pro-Lifter 20 is turned off
1. The GRABO® Pro-Lifter 20 is turned on and
ready for use
2. Pressure is building up and reaching its
maximum capacity
3. Pump is switched off
Pump is switched on; pressure is low and building
up
Pump is switched on but the motor is off;
pressure has reached its maximum capacity
Battery is sufficiently charged
Battery capacity is low/empty
1 Bar = 20% full
2 Bar = 40% full
3 Bar = 60% full
4 Bar = 80% full
5 Bar = 100% full
Meaning
Battery is charging
Battery is fully charged
21