Registering Your Product - Grabo PRO-LIFTER 20 Manual Del Operador

WARRANTY DOES NOT APPLY TO FAILURES DUE TO:
Freight damage.
l
Misuse, overloading, or accidental activation of the tool in storage.
l
Damage caused by parts or accessories not obtained from an authorized dealer or not
l
approved by Nemo Power Tools.
Normal wear of moving parts or consumables, such as seals and filters.
l
7-YEAR LIMITED WARRANTY
This applies only to certain categories of tools. Please check with our Las Vegas Warranty Center at
+1 (702)-718-2433 if your tool category is eligible.

Registering your product

GRABO® products mostly include a basic warranty plan. Registering your product after your
purchase from a licensed dealer may extend your warranty and grant you further benefits (subject
to your product type, location, and place of purchase). Registration is free and simple.
Please locate your product's serial number and complete the provided form. Register online for
warranty: www.GRABO.com/REG
TROUBLESHOOTING
www.GRABO.com/GRABO-pro-troubleshoot
NOTICE: If you are having any issues with your digital display, please perform the following steps to
reset your digital display.
GRABO® Pro-Lifter 20 learning mode/recalibration mode:
1. Place the GRABO® Pro-Lifter 20 on a non-porous surface such as a polished tile.
2. Slide the power ON/OFF switch Ⓓ into the ON position.
3. Press the measurement unit selector Ⓕ for 10 seconds. When the red light turns green, release
the measurement unit selector Ⓕ .
4. Wait for about 5 seconds. The vacuum pump will start working. Let the device create full
suction. If suction does not start on its own, push the device downward to create a seal. Full
suction is reached when the digital display numbers have reached their highest point and don't
continue to increase.
5. When full suction is reached, press the measurement unit selector Ⓕ again for 3 seconds until
the green light flashes and the pump turns off.
6. Turn the device off and on again with the the power ON/OFF switch Ⓓ .
The device is now calibrated and the values in the digital display window should be correct.
GRABO® PRO-LIFTER 20 | Operator's manual
23